Hi Leute!
Ich habe ein neus Projekt, Patton 4552 mit VCX Connect 200 ins lauf zubekommen.
Leider kenn ich mich mit Patton nicht sehr gut aus.
Allerdings habe ich eine Config bekommen, die funktionieren sollte sie tut es leider nicht,
jetzt bräuchte ich eure Hilfe um den Fehler einzugrenzen bzw. zu lösen.
Hier die Config im Patton 4552
Zusätzlich ist noch eine alte con fig von 3CX drin.
Ausgabe im Patton debug
Bitte um eure Hilfe.
Danke
Macsea
Ich habe ein neus Projekt, Patton 4552 mit VCX Connect 200 ins lauf zubekommen.
Leider kenn ich mich mit Patton nicht sehr gut aus.
Allerdings habe ich eine Config bekommen, die funktionieren sollte sie tut es leider nicht,
jetzt bräuchte ich eure Hilfe um den Fehler einzugrenzen bzw. zu lösen.
Hier die Config im Patton 4552
Zusätzlich ist noch eine alte con fig von 3CX drin.
Code:
#----------------------------------------------------------------#
# #
# SN4552/2BIS/EUI #
# R5.6 2011-03-10 SIP #
# 1970-07-17T00:16:35 #
# SN/00A0BA062CC0 #
# Generated configuration file #
# #
#----------------------------------------------------------------#
cli version 3.20
clock local default-offset +00:00
webserver port 80 language en
system
ic voice 0
profile ppp default
profile call-progress-tone defaultDialtone
play 1 1000 450 -6
profile call-progress-tone defaultAlertingtone
play 1 1000 450 -13
pause 2 5000
profile call-progress-tone defaultBusytone
play 1 300 450 -7
pause 2 300
profile call-progress-tone defaultReleasetone
play 1 300 450 -7
pause 2 300
profile call-progress-tone defaultCongestiontone
play 1 300 450 -7
pause 2 300
profile tone-set default
profile voip default
codec 1 g711alaw64k rx-length 20 tx-length 20
codec 2 g711ulaw64k rx-length 20 tx-length 20
ced net-side-detection
fax transmission 1 relay t38-udp
fax redundancy low-speed 1 high-speed 1
fax relay-detection-timeout 120
profile pstn default
profile sip default
autonomous-transitioning
profile aaa default
method 1 local
method 2 none
context ip router
interface IF_IP_WAN
ipaddress dhcp
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
interface IF_IP_LAN
ipaddress 10.1.22.3 255.255.255.0
tcp adjust-mss rx mtu
tcp adjust-mss tx mtu
context cs switch
routing-table called-e164 RT_ISDN_TO_SIP_0
route 29423557T!0 dest-interface IF_SIP_3COM MAPPING_INCOMING_CALLS
route 2942355718 dest-interface IF_SIP_0 MAPPING_INCOMING_CALLS
routing-table calling-e164 RT_SIP_TO_ISDN_0
route * dest-interface IF_ISDN_0
mapping-table calling-pi to calling-e164 MAP_REMOVE_BLANK_CALLERID
map restricted to ""
mapping-table calling-e164 to calling-e164 MAP_LEADING_ZERO
map (.%)-(.%)-(.%)-(.%)-(.%) to 0\1\2\3\4\5
map (.%)-(.%)-(.%)-(.%) to 0\1\2\3\4
map (.%)-(.%)-(.%) to 0\1\2\3
map (.%)-(.%) to 0\1\2
map (.%) to 0\1
mapping-table calling-e164 to calling-name MAP_CID_TO_CNAME
map (.%) to \1
mapping-table calling-e164 to calling-e164 MAP_MSN_TO_OUTGOING
map * to 029423557
map (.%) to 029423557
complex-function MAPPING_INCOMING_CALLS
execute 1 MAP_REMOVE_BLANK_CALLERID
execute 2 MAP_LEADING_ZERO
execute 3 MAP_CID_TO_CNAME
interface isdn IF_ISDN_0
route call dest-table RT_ISDN_TO_SIP_0
call-hold disable
no early-proceeding
caller-name
user-side-ringback-tone
interface sip IF_SIP_0
bind context sip-gateway GW_SIP_0
route call dest-interface IF_ISDN_0
remote 10.40.41.10 5060
early-connect
early-disconnect
address-translation outgoing-call request-uri user-part fix 10001 host-part to-header target-param none
interface sip IF_SIP_3COM
bind context sip-gateway GW_SIP_3COM
route call dest-interface IF_ISDN_0
remote 10.1.22.2 5060
early-connect
early-disconnect
address-translation incoming-call calling-e164 fix 029423557
context cs switch
no shutdown
authentication-service AS_ALL_LINES
realm 1 3CXPhoneSystem
username 10001 password sdfgdfg encrypted
location-service LS_10001
domain 1 10.40.41.10
identity-group default
authentication outbound
authenticate 1 authentication-service AS_ALL_LINES username 10001
identity 10001
authentication outbound
authenticate 1 authentication-service AS_ALL_LINES
registration outbound
registrar 10.40.41.10 5060
lifetime 300
register auto
location-service LS_3COM
domain 1 10.1.22.2
context sip-gateway GW_SIP_0
interface LAN
bind interface IF_IP_LAN context router port 5060
context sip-gateway GW_SIP_0
bind location-service LS_10001
no shutdown
context sip-gateway GW_SIP_3COM
interface lan
bind interface IF_IP_LAN context router port 5061
context sip-gateway GW_SIP_3COM
bind location-service LS_3COM
no shutdown
port ethernet 0 0
encapsulation ip
bind interface IF_IP_WAN router
shutdown
port ethernet 0 0
no shutdown
port ethernet 0 1
encapsulation ip
bind interface IF_IP_LAN router
no shutdown
port ethernet 0 1
no shutdown
port bri 0 0
clock auto
encapsulation q921
q921
protocol pp
uni-side auto
encapsulation q931
q931
protocol dss1
uni-side user
bchan-number-order ascending
encapsulation cc-isdn
bind interface IF_ISDN_0 switch
port bri 0 0
no shutdown
port bri 0 1
clock auto
encapsulation q921
q921
uni-side auto
encapsulation q931
q931
protocol dss1
uni-side net
bchan-number-order ascending
port bri 0 1
shutdownAusgabe im Patton debug
Code:
00:22:11 CR > [switch] Routing-Lookup:
00:22:11 CR > Execute all entries in table IF_ISDN_0-precall-service
00:22:11 CR > Find best-matching called-entry in table RT_ISDN_TO_SIP_0
00:22:11 CR > 00: Prefix Timeout Expression: called-e164 of incompletely matches ^(?:29423557)
00:22:11 CR > 01: Prefix Timeout Expression: called-e164 of incompletely matches ^(?:2942355718)
00:22:11 CR > NO MATCHING ENTRY (INCOMPLETE ENTRIES PRESENT)
00:22:11 CR > Lookup result: Route not found (incomplete address) (timeout=0)Bitte um eure Hilfe.
Danke
Macsea